Difference between revisions of "Dikablis D-Lab"
Line 10: | Line 10: | ||
Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(-sub-sub)conditions as shown in the picture below. | Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(-sub-sub) conditions as shown in the picture below. | ||
<center>[[File:Test p tasks menus sub.png]]</center> | <center>[[File:Test p tasks menus sub.png]]</center> | ||
Revision as of 22:08, 18 October 2012
AOIs and Gaze Statistics
-dlab software -import dikablis- select a recording and scene in left panel, can analyze recalibrated files-can add area of interest either for whole project or particular subject, can calculate gaze statistics, e.g., how often/long looked at region -click new, define using left and right clicks, select marks, press ok -compute gaze behaviour
Creating New Conditions
In D-Lab, select the "Test procedure" tab near the top-left. Then press the "New Test Procedure" button at the top as shown,
![Test p1.png](/images/thumb/2/27/Test_p1.png/501px-Test_p1.png)
Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(-sub-sub) conditions as shown in the picture below.
![Test p tasks menus sub.png](/images/4/48/Test_p_tasks_menus_sub.png)
Setting Within Subject Conditions in D-Lab
It is possible to set within-subject conditions manually, after the each subject's video has been recorded. However it is much easier and less time consuming to remotely set conditions through the D-Lab Control software.
Note that within-subjects conditions are called "Use Cases" in the Dikablis manuals.
Manually Setting Conditions
- after the fact* creating test procedure, (condition vs. task, subtask, etc.): d-lab manual 22/107
Remotely Setting Conditions in Control Centre
in order to remotely set conditions through Control software, you must first create a common test procedure (?).
d-lab manual: 24/107, 98/107