Difference between revisions of "Dikablis D-Lab"

From REALab Wiki
Jump to navigation Jump to search
Line 10: Line 10:




Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(sub)conditions as shown in the picture below.
Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(-sub-sub)conditions as shown in the picture below.
<center>[[File:Test p tasks menus sub.png]]</center>
<center>[[File:Test p tasks menus sub.png]]</center>



Revision as of 22:08, 18 October 2012

AOIs and Gaze Statistics

-dlab software -import dikablis- select a recording and scene in left panel, can analyze recalibrated files-can add area of interest either for whole project or particular subject, can calculate gaze statistics, e.g., how often/long looked at region -click new, define using left and right clicks, select marks, press ok -compute gaze behaviour

Creating New Conditions

In D-Lab, select the "Test procedure" tab near the top-left. Then press the "New Test Procedure" button at the top as shown,

Test p1.png


Browse to the folder you would like to save your test procedure in and save the XML file. Once this is done you should see a new condition under the "Test procedure" tab. Right-click the new condition to edit it or create additional conditions or sub(-sub-sub)conditions as shown in the picture below.

Test p tasks menus sub.png

Setting Within Subject Conditions in D-Lab

It is possible to set within-subject conditions manually, after the each subject's video has been recorded. However it is much easier and less time consuming to remotely set conditions through the D-Lab Control software.

Note that within-subjects conditions are called "Use Cases" in the Dikablis manuals.


Manually Setting Conditions

  • after the fact* creating test procedure, (condition vs. task, subtask, etc.): d-lab manual 22/107

Remotely Setting Conditions in Control Centre

in order to remotely set conditions through Control software, you must first create a common test procedure (?).

d-lab manual: 24/107, 98/107